StewartGreen
Reviewer
4/5
A good powerful machine. Easy to assemble and easy to start. Very good value for money and the ear d...
Show More
Show More
efenders do the job well. Comes with good supply of chains in both sizes. Makes easy work of big logs. Customer services fantastic when I had a little trouble with pull cord, and immediately sent a replacement.
Show Less
Show Less
11 months ago
peter janssen
Reviewer
5/5
alles besten
super gute leistung
3 years ago
Amy Callaghan
Reviewer
5/5
Not easy to assemble
Allow 3 hrs to assemble .Its not easy to assemble but the inst...
Show More
Show More
ructions are very good.Be extra carefull the edges of the stainless steel pannells are razor sharp .I recieved multiple hand cuts as a result.May be wear gloves while assembling the heater .Once you get it put together its a great job.The heat out put is very good .
Show Less
Show Less
3 years ago
A M STURGESS
Reviewer
5/5
excellent
like every think about this model. cuts lovely
3 years ago
Cliente Amazon
Reviewer
5/5
Ok
Ok
3 years ago
Amazon Kunde
Reviewer
5/5
Effektiv und gutes Preis leistungsverhältnis.
Praktisch im Rucksack zu arbeiten.
3 years ago
Les
Reviewer
5/5
Good value for money
All good thankyou
3 years ago
Adrian D
Reviewer
5/5
Looks good - Read the instructions.....Carefully.
It is not hard to put together al...
Show More
Show More
though the instructions are misleading. Pay close attention. Its easy to miss some screws on the frame, and also to not ensure the side where the panel drops in to cover the gas bottle is the side where the controls are. We had to take it half apart again. Mkae sure the slots at the bottom face the same way as control knob. You have been warned! Other than that its fine, reasonable output, looks good, and the cover that comes with it is also pretty reasonable quality. Would I buy it again at that price. Yes I would.
One person found this helpful
Show Less
Show Less
3 years ago
Amazon Customer C Stevenson
Reviewer
3/5
A bit of a disappointment
On paper, sounds very good, and I saw a review which rate...
Show More
Show More
d it highly. All the tools, plus two extension poles, so worth a try. However, you see many of these with identical hardware badged under different brands.First problem was the handle - it had a locating lug but there was no corresponding hole in the shaft to locate the handle into, and so the handle could not be fitted without drilling a hole in the shaft - I didn't do it. So there is a picture of the shaft and the handle with the lug.Starting it up, the throttle sticks on high. The design of this is the same on all the other clone ones I saw, not very good.The label for choke operation was put on upside down, so choke would be off when you thought it was on.The plastic felt very cheap, and the accessories were very flimsy and lightweight.Good points were the splined shaft, and the fact the shaft ran in bearings, but were they good quality?It's heavy, and after trying it for a few seconds on the hedge cutter, I drained all the fuel and asked for a refund.Sending it back was ok, a pre-paid label was issued, but dropping it in at a Post Office was a pain - it's a big heavy box.Having said that, refund was smooth so I can't complain about that.Most of it was made in PRC , but some bits had 'Japan' stamped on them.You pay your money and you take your choice, except P.R.C has eliminated most of the competition.
3 people found this helpful
Show Less
Show Less
3 years ago